Heater-craft 450 Yamaha Rhino Manual do Utilizador

HEATER CRAFT YAMAHA RHINO 450 INSTALLATION INSTRUCTIONS & OWNER’S MANUAL

KIT CONTENTS: QTY. 1 HEATER UNIT QTY. 2 MOUNTING BRACKETS QTY. 1 OVAL VENT QTY. 4.00” OF TRIM RUBBER QTY. 8’ OF 2.00” VENT HOSE QTY. 2 VENTS (2

MOUNT HEATER UNIT: Install brackets as shown using provided #8-32 screws provided. Remove the battery box cover and loosen the four (4) retai

PLUMBING: Remove lower radiator hose and drain into catch pan. Install and clamp the provided coupling in the open end of the removed radiator

PLUMBING: cont. Install the 4.00” piece of Trim Rubber on the vertical edge of the radiator to protect the installed heater hose. VENTS

VENTS AND HOSE ROUTING Cont. Place the oval vent’s plenum under the dash and sandwich the dash between the grill and plenum. Use the #10 x 3/4” screw

WIRING/ELECTRICAL: Locate Black ground wire from heater motor and cut/route to the Negative post on the battery using the provided Ring Terminal.